User's Manual

45
Mounting and connecting remote antennas
Use a remote antenna when the transmitter position is not the
best antenna position for optimum transmission. You can
choose between two antennas (see “Accessories” on page 58):
y A 2003 UHF passive directional antenna
y A 1031 passive omni-directional antenna
Use a low-attenuation 50-Ω cable to connect the antenna to the
transmitter. Ready-made antenna cables from Sennheiser are
available as accessories with length of 5 m and 10 m. If possible,
use a short antenna cable and as little connections as possible,
since long cables and many connectors lead to an attenuation
of the antenna signal. Position antennas in the same room in
which the transmission takes place! Maintain a minimum
distance of 1 m from metal objects (including reinforced
concrete walls)!
Connecting the mixing console
Connect the mixing console to the XLR-3 sockets AF IN (L) 
and AF IN (R) + MONO .
Note
Any unit that is only suitable for mono operation must be
connected to the XLR-3 socket AF IN (R) + MONO . In this
case, set the transmitter to mono operation (see “Switching
between mono and stereo operation” on page 51).
A 2003
A 1031
SR3254_56.book Seite 45 Samstag, 10. September 2005 2:53 14