System Manual

GuidePort: System Manual 27. November 2000 Seite 6
2.3.2 Hardware Interfaces
a) Front panel
Headphone Outputs
Allow you to monitor the audio signals transmitted to the receivers.
b) Rear panel
USB IN:
Input socket for the USB cable from the Base Station PC.
ANALOG IN SYM.:
Inputs for connecting your audio sources to the transmitter. There are four balanced
inputs, you can either connect 4 mono sources, 2 mono sources and 1 stereo source or
2 stereo sources. For a stereo audio source, you will need two sockets (left and right
channel), please use inputs 1 & 2 and/or 3 & 4. Connect the left audio channel to
socket No. 1 or 3, the right audio channel to No. 2 or 4, respectively.
The following table shows how to connect your audio sources to the GuidePort Cell
Transmitter:
Number and kind of audio
sources
Input No. 1 Input No. 2 Input No. 3 Input No. 4
4 mono (m) m m m m
2mono(m),1stereo(s) m m s,left s,right
2 stereo (s) s, left s, right s, left s, right
AAU OUT
Output for connection of an Active Antenna Unit. Use a shielded, 8-wire twisted pair
cable (4 individually twisted pairs) for connection. This cable supplies the Active
Antenna Unit with DC and the digital data stream to be transmitted.
SET SET
Gu
i
de
P
o
r
t
SR
3000
-2
TX I TX II
TX II
AAU OUT
0
I
USB IN
ANALOG IN SYM.
TIP: +
RING:
-
1
2
3
4
TX I
AAU OUT
USB IN
ANALOG IN SYM.
TIP: +
RING:
-
1
2
3
4