User's Manual
Table Of Contents
- For your safety
- The ADN-W AM antenna module
- Package contents
- Components required for wireless operation
- Product overview ADN-W AM
- Preparing the antenna module for operation
- Setting up and positioning the antenna module
- Connecting the ADN-W AM antenna module to the ADN CU1 central unit
- Switching the antenna module on/off
- Configuring the wireless components
- Cleaning and maintaining the antenna module
- Specifications ADN-W AM
Preparing the antenna module for operation
6|ADN-W AM
Connecting the antenna module to the mains power
supply
The antenna module is powered from the ADN CU1 central unit via the
SBC CBL RJ45 system cable.
왘 Connect the hollow jack plug of the NT 12-50C power supply to
the hollow jack socket .
왘 Pass the cable through the cable grip as shown.
왘 Connect the Euro 8 connector of the mains cable to the socket of
the NT 12-50C power supply.
왘 Connect the mains plug of the mains cable to a wall socket.
If the power supplied via the system cable is not sufficient and
if the antenna module is not listed in the central unit‘s oper-
ating menu under “
System Menu” > “Versions” > “Hardware
Version Info
” or “Software Version Info”:
왘 Use the optional NT 12-50C power supply.
CAUTION
Product damage due to an unsuitable power supply!
If you use an unsuitable power supply, this can cause damage to the
ADN-W AM antenna module.
왘 Only connect the NT 12-50C power supply to the antenna module.
Software Version Info
Main menu
System menu
Versions
No
Hardware Version Info
CU1 SB: 1
ADN PS: 1
AM 1
2
5
EU
UK
US
5
NT 12-50C
2
3
2
2
3