User's Manual

Preparing the ADN-W D1/C1 wireless conference units for operation
8 | ADN C1/ADN D1 | ADN-W C1/ADN-W D1
If you screw the microphone to or unscrew it from the wireless
conference unit during operation (wireless conference unit is switched
on), proper functioning of the conference unit cannot be guaranteed,
i.e. volume differences or noise may occur.
왘 First connect the microphone and then switch the conference unit on.
Inserting/removing the battery pack
To insert the ADN-W BA battery pack into the wireless conference unit:
왘 Check the battery pack before using it in order to ensure sufficient
battery capacity and to exclude a defective battery pack (see the
instruction manual of the battery pack).
왘 Charge the battery pack if necessary (see the instruction manual of
the battery pack).
왘 Slide the battery pack into the battery guide rails of the wireless
conference unit.
The battery release clip locks into place with an audible click and
secures the battery pack.
To remove the battery pack from the wireless conference unit:
왘 Press the battery release clip and pull the battery pack out of
the battery guide rails.
Switching the wireless conference unit on/off
To switch the wireless conference unit on:
왘 Press the microphone key .
The microphone LED and the signal light ring flash red and
the RF status indicator on the ADN-W BA battery pack flashes
blue slowly. Once the initialization process is complete and after
connection to the ADN-W AM antenna module is established, the
microphone LED
and the signal light ring go off. The RF status
indicator on the ADN-W BA battery pack indicates the
transmission quality:
C
8
C
8
8
8
7
8
2
2
8
2
2