User's Manual
Table Of Contents
- Safety instructions
- Contents
- The 2015 System
- Delivery includes
- Operating controls of the EK 2015 receiver
- Operating controls of the SK2015 transmitter
- Preparing the units for use
- Using the receiver
- Using the transmitter
- Troubleshooting
- Care and maintenance
- Configuration of the units by the technical expert
- Specifications
- Accessories
- Notice d’emploi
- Pour votre sécurité
- Sommaire
- Le système 2015
- Fournitures
- Les éléments de commande du récepteur EK 2015
- Les éléments de commande de l’émetteur SK2015
- Utilisation quotidienne
- Utiliser le récepteur
- Utiliser l’émetteur
- En cas d'anomalies
- Entretien et maintenance
- Configuration des appareils par le spécialiste technique
- Caractéristiques techniques
- Accessoires
16
battery cells have different discharging curves. Transmitter and
receiver are able to identify the BA 2015 accupack and to use its
capacity to the full. They also adapt the battery status display
according to the type of power supply used (batteries or accupack).
Individual rechargeable battery c ells will not be identified as accupac k s.
y If you do not use the transmitter or receiver, remove the accupack or
the batteries. After three months at the latest, the accupacks will need
a refresh charge in the L2015 charger.
If you do not use the transmitter or receiver for extended periods of
time (e.g. while you are on holiday), we rec ommend storing it in the
L 2015 cha rger which is connected to the mains. This prevents dam age
to th e acc upa ck d ue to to ta l d isc harge.
Connecting the receiver to hearing aids
Connecting the receiver to hearing aids with audio input
Connect a hearing aid with audio input to the receiver’s 2.5 mm jack
socket (HI) . Suitable connecting cables (see “Accessories” on page 51)
are available from your Sennheiser dealer.
Connecting the receiver to a hearing aid without audio input
Connect the EZT 2015 induction neck loop or the EZI 120 induction
couplers for hearing aids without audio input to the receiver’s 3.5 mm jack
socket (LOW) . Suitable connecting cables for the induction couplers
(see “Accessories” on page 51) are available from your Sennheiser dealer.
Connecting the headpho nes
You must only connect headphones with a stereo jack plug and a minimum
impedance of 32 Ω to the receiver.
Connect the headphones to the receiver’s 3.5 mm jack socket .