User's Manual

44
display and the display then displays the next channel that can be
released.
 Have your released all required channels as described above? Store your
settings by pressing the SET button until “STORED” appears on the
display.
Selecting the frequencies to be stored in the channel bank “U”
TUNE Via the “TUNE” menu, you can select the frequencies to be stored in the
channel bank “U” (user bank). When selecting the “TUNE” menu, the
transmitter or receiver automatically switches to the channel bank “U”.
Note:
Always assign the same frequency to the same channel on both
transmitter and receiver.
 Use the / rocker button (UP/DOWN) to select the channel for which
you want to set the frequency.
 Press the SET button to confirm your selection. The currently set
frequency is displayed.
 Us e the / r ocker button (UP/D OWN) to s elect th e desi red trans mis sio n
or receiving frequency. The frequencies are tunable in 25-kHz steps within
a switching bandwidth of 36 MHz max. For intermodulation-free
frequencies, please refer to the enclosed frequency table.
 Press the SET button to store your setting.
Enteri ng a na me
NAME Via the “NAME” menu, you can enter a freely selectable name for the
transmitter or receiver. This name is briefly shown on the displa y pa nel after
switch-on.
The name can consist of up to six characters such as:
y letters (without pronounciation marks),
y numbers fro m 0 to 9,
y special characters e.g. () - . _ and spaces.