User's Manual
57
Recommendations and tips
... for the ME 2 and ME 4 clip-on microphones
y To reduce level variations to a minimum when the user
turns his or her head away from the microphone, attach
the microphone as centrally as possible.
y To protect the microphone against excessive sweat/
moisture, avoid direct skin contact.
y Attach the microphone carefully and conduct the cable so
that noise due to friction is avoided.
y Always use the ME 4 directional microphone with a
windshield and direct the microphone towards the sound
source (e.g. mouth).
... for the ME 3 headmic
y Always use the microphone with a popshield and position
the microphone at the corner of the mouth.
y You can vary the bass reproduction by increasing/
decreasing the talking distance.
y Make sure that the sound inlet is directed towards the
mouth. The sound inlet is marked with a little dot.
... for the bodypack transmitter
y Make sure that the antenna and the microphone cable do
not cross.
y The antenna should hang freely and be at least 1 cm away
from the body. The antenna must not be in direct contact
with the skin.
y For best results, make sure that the transmitter
sensitivity is correctly adjusted.
... for optimum reception
y Transmission range depends to a large extent on location
and can vary from about 10 m to about 150 m. There
should be a “free line of sight” between transmitting and
receiving antennas.
y To avoid overmodulating the receiver, observe a
minimum distance of 5 m between transmitting and
receiving antennas.
... for multi-channel operation
y For multi-channel operation, you can only use the
channels in a channel bank. Each of the channel banks “1”
to “8” accommodates up to 20 factory-preset
frequencies which are intermodulation-free. For
alternative frequency combinations, please refer to the
enclosed frequency table. The freely selectable
frequencies can be selected via the “TUNE” menu and can
be stored in the channel bank “U”.
y When using several transmitters simultaneously,
interference can be avoided by maintaining a minimum
distance of 20 cm between two transmitters.