User's Manual

DE
EN
FR
IT
ES
NL
11
Putting the MM 450 into operation
Pairing the headset with an audio source
E
Press the Master button e and keep it pressed until the Star LED a
flashes 3 times red.
The headset switches off (see “Switching the headset off” on page 15).
E Press the Master button e and keep it pressed until the Star LED a
alternately flashes blue and red.
E On your audio source, activate the Bluetooth function “Add a new
device”.
E Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identi-
fication information. The
Star LED a flashes 3 times blue and you hear an
ascending beep. The devices have identified each other and the headset is
paired with the audio source.
If a connection is established, the
Star LED a continues to slowly
flash blue.
If no device is found within approx. 5 minutes, the
Star LED a flashes
3 times red and you hear a descending beep. The headset will then try for
3 minutes to connect to one of the 5 known audio sources. If this fails, the
headset automatically switches off.
E In this case, repeat the necessary steps to pair the headset with the
audio source again.
Switching the “Bluetooth connection” flashing on/off
E
Switch the headset off (see “Switching the headset off” on page 15).
To switch the “Bluetooth connection” flashing
off:
E Press the Master button e and keep it pressed until the Star LED a
alternately flashes blue and red.
E Press the Volume " button c for more than 3 seconds.
To switch the “Bluetooth connection” flashing
on again:
E Press the Volume # button f for more than 3 seconds.
5
1
5
1
2s
1
PIN code
When the audio source prompts for a password or PIN code,
enter the default PIN code “0000”.
1
3s
1
5
1
2s
3
6