User's Manual

Adjustment tips for the operating menu

Adjusting the microphone sensitivity –

“ATTEN”

Via the “ATTEN” menu, you can adjust the radio microphone’s sensitivity

by changing its input attenuation.

Adjusting the low-cut frequency –

“LOWCUT”

To reduce unwanted low-frequency noise such as engine, wind and rumble

noise, you can activate a low-cut filter. The low-cut frequency can be set to

190 Hz or 120 Hz.

If you do not want to reduce low-frequency signal portions, select the set-

ting “FLAT”.

Selecting the standard display – “VIEW”

Via the “VIEW” menu, you can select one of the following standard dis-

plays:

The selected standard display is shown

• after switch-on,

• after the menu settings have been displayed in display mode.

The input attenuation is correctly adjusted

when the level display for audio signal “AF”

shows full deflection  only during the lou-

dest passages. The input attenuation can be

adjusted in 1-dB steps from –40 dB to 0 dB.

The bargraph has a resolution of approx. 3 dB per segment with a

display range of 45 dB.

Transmission frequency

“FREQ”

Channel

“CHAN”

Name

“NAME”



MHz