User's Manual

EN Putting the RS 5000 into operation
12 | RS 5000
Displaying the remaining operating time of the
rechargeable battery
When you switch the stethoset receiver on, the Battery LED
displays the remaining operating time/charge status.
To indicate that the operating time is decreasing, each LED
segment slowly dims before it goes off completely.
If the actual operating time differs widely from the specified
values, the rechargeable battery is probably exhausted and
should be replaced. Information on the rechargeable battery
can be found on page 23.
Battery LED flashes
rapidly
A charging error/battery error has
occurred (see page 23).
Always store the stethoset receiver in the transmitter’s
charging compartment to ensure that it is fully charged
when needed. The intelligent battery charging technol-
ogy prevents overcharging.
The display during charging can be set so that it auto-
matically switches off after 30 seconds (see page 25).
Battery LED Meaning
Battery LED flashes slowly
Rechargeable battery is empty;
recharge it
1
st
segment lit
approx. 4 hrs of operating time
1
st
+ 2
nd
segments lit
approx. 8 hrs of operating time
All segments lit
approx. 12 hrs of operating time
The display of the remaining operating time can be set
so that it automatically switches off after 30 seconds
(see page 25).
If more than one stethoset receiver is connected to the
transmitter, the remaining operating time/charge
status cannot be displayed.
Battery LED Meaning
RS_5000_570727_0117_PRT.book Seite 12 Montag, 10. Oktober 2016 2:52 14