User's Manual

EN Using the RS 5000
14 | RS 5000
Using the RS 5000
Switching the wireless headphone system on
1 Switch your audio source on.
If the transmitter is connected to the head-
phone socket (see page 8) of your TV/audio
source, adjust the volume of the headphone
socket on your TV/audio source to at least a
medium level.
2 Take the stethoset receiver out of the transmitter’s
charging compartment and pull the ear bows apart so that
you can put the receiver on.
The stethoset receiver automatically switches on when you
pull the ear bows apart. The
Receiver status LED lights up
green. The transmitter automatically switches on and the
Transmitter status LED lights up white or blue. The audio
transmission starts.
The remaining operating time of the stethoset receiver is
displayed on the transmitter (see page 12).
WARNING
Danger of hearing damage due to high volumes!
This stethoset receiver allows you to set higher vol-
umes than conventional devices. Constant high-vol-
ume use can cause hearing damage.
왘 Before putting the stethoset receiver on, set the vol-
ume on the receiver to a low level.
왘 Do not expose yourself to high volume levels for
extended periods of time.
왘 Use a hearing profile (see page 18) that improves
especially speech intelligibility without the need for
a high volume.
VOLUME
ON
ON
2
1
RS_5000_570727_0117_PRT.book Seite 14 Montag, 10. Oktober 2016 2:52 14