e 865/e 865 S Instruction manual
Delivery includes Delivery includes • e 865 / e 865 S • MZQ 800 microphone clamp • pouch • quick guide • safety guide Product overview 1 3 4 2 1. Sound inlet basket 2. XLR-3 connector 3. On/off switch (e 865 S only) 4.
Installation Installation Attaching the microphone Screw the microphone clamp to a stand. Place the microphone with its back end into the microphone clamp. Orient the microphone together with the microphone clamp. Connecting the microphone Connect the XLR-3 socket of the microphone cable (optional accessories) to the XLR-3 socket of the microphone. Using the windshield Place the MZW 4032 (optional accessories) windshield over the microphone head.
Operation Operation Holding the microphone If you cover the microphone head during transmission, this will change the pick-up pattern of the microphone and consequently the sound. Only hold the microphone by its body.
Operation Positioning the monitor loudspeakers To prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the highest cancellation of the microphone (approx. 135°). 135° Switching the e 865 S on/off Use the on/off switch to switch the the e 865 S on or off. If necessary, use the screw to lock the on/off switch in the „on“ position.
Cleaning and maintaining the e 865 / e 865 S Cleaning and maintaining the e 865 / e 865 S CAUTION LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT! Liquids entering the housing of the product can cause a short-circuit and damage the electronics. Keep all liquids away from the product. Do not use any solvents or cleansing agents. Disconnect the products from the power supply system and remove rechargeable batteries and batteries before you begin cleaning. Clean all products only with a soft, dry cloth.
Specifications Specifications Transducer principle pre-polarized condenser microphone Frequency response 40 - 20,000 Hz Pick-up pattern super-cardioid Sensitivity (free field, no load) 3 mV/Pa Nominal impedance (at 1 kHz) 200 Ω (balanced) Min. terminating impedance 1 kΩ Max.
Overview of applications Connector assignment 1 3 2 + + XLR 1 3 + 2 3 + 1 2 XLR 2 3 1 XLR + + XLR BALANCED 6.
