Owner's Manual
Table Of Contents
- Instruction Manual
- Supplied Accessories
- Table of Contents
- Safety
- Parts & Controls
- Getting Started
- Operation
- Transmitter Power On / Off
- Receiver Power On / Off
- Putting the Receiver On
- Adjusting the Volume
- Searching for a Sound Source
- Adjusting the Balance
- Stereo / Mono
- Individually Enhancing the Speech Intelligibility
- Storing and Charging the Receiver
- Charging a Rechargeable Battery in the Transmitter’s Charging Compartment
- What If...
- Cleaning the System
- Troubleshooting
- Fine Adjusting the Speech Intelligibility
- Accessories & Spare Parts
- Specs
- Index
- Connection Diagram
13
Using the Set 840-TV system
Switching the receiver on/off
Switching the receiver off
왘 Take the receiver off.
The receiver automatically switches off after 30 seconds.
For how to store and charge the receiver, refer to page 18.
CAUTION! Hearing damage due to high volumes!
This receiver allows you to set higher volumes
than conventional headphones. This can
cause hearing damage in persons with
healthy hearing and especially in children.
왘 Before putting the receiver on, set the
volume on the receiver to a low level.
왘 Do not continuously expose yourself to
high volumes.
Switching the receiver on
The receiver automatically switches
on when you pull the earbows
apart.
Putting the receiver on
왘 Put the receiver on the correct
way round, with the Sennheiser
logo facing away from your
body.
The ear pads adapt to the ear
form and thus increase the
wearing comfort.
If you are not within the range of the transmitter, the
receiver automatically switches off after 3 minutes.