User Manual

MB Pro1 | MB Pro 2 | 17
Using the headset
Making calls using the headset
Making a call
X Dial the desired number on your mobile phone or softphone.
You hear a beep in the headset.
If your mobile phone does not automatically transfer the call to the headset:
X Press the multi-function button on the headset or press a corresponding button
on your mobile phone (see the instruction manual of your mobile phone).
Accepting/rejecting/ending a call
When you receive a call, the headset announces which of the connected Blue-
tooth device is ringing:
• connected mobile phones: “Phone one” or “Phone two” or
• Bluetooth dongles connected to the PC: “Dongle“
You then hear a ring tone in the headset and the LED flashes blue. If the headset
battery is low, the LED flashes red.
X Press the multi-function button:
Duration Function Voice prompt/beeps
Accepts a call
1 s
Rejects a call ”Call rejected”
2 x
Puts an active call on hold
(pause)
–
Ends a call ”Call ended”
To accept a call while the headset is being charged:
X Take the headset from the magnetic holder of the charging cable. The headset
switches on and the call is automatically accepted.
X Place the headset back into the magnetic holder to end the call and to con-
tinue charging the rechargeable battery.
To accept a call when the headset is switched off:
X Simply switch your headset on.
When the voice prompts are disabled, you hear a beep in the headset.
When you listen to music, the music is paused until you end the call. This function
is not supported by all mobile phones.
Phone
one