Instruction manual Digital 9000 System

Digital 9000 | 63
Using the EM 9046
“Audio output level” – Adjusting the analog output levels
Via the “Audio output level” menu item, you can adjust the level of all or
individual channels of the Analog Audio Out (AAO) module.
왘 Call up the “Audio output level” menu item.
The installed audio modules are displayed as follows:
- digital audio modules: “Slot digital”;
- analog audio modules: “Slot analog”;
- not installed audio modules: “Slot not available”.
왘 Select individual or all channels of the AAO module by turning
the jog dial to the left/right. Selected channels are highlighted
in blue.
왘 Call up the level adjustment by pressing the jog dial. The outer
ring of the channel is highlighted in blue.
왘 Adjust the level.
The setting becomes effective immediately.
왘 Press the jog dial to confirm your setting and to return to the channel
selection.
왘 Adjust the level of further channels.
왘 Press the button F. Your settings are stored and the receiver then
switches to the main menu.
To change to the main menu without storing your settings:
왘 Press the esc button L.
If you call up the level adjustment of all channels, the smallest value
adjusted for a channel is displayed in the menu selection. By turning
the jog dial, you can adjust the level of all channels to the value dis-
played in the menu selection.
Audio output level
output level
0000
000
0
0
0
0
1234
5678
EM 9046 AAO EM 9046 DAO
Analog multicore
0
0