BDA ADN-W C1 D1 ADN C1 D1

Preparing the ADN-W D1/C1 wireless conference units for operation
2
2
8
7
ADN-W BA
Status-LED RF status indictor 2
Color Meaning
- good transmission quality
blue, flashing
slowly
transmission quality is
temporarily reduced
blue, flashing
rapidly
transmission quality is
permanently reduced
If no connection to an antenna module can be established within 5
minutes, the wireless conference unit automatically switches off.
To switch all wireless conference units off:
Set the on/off switch of the ADN CU1 central unit to position „0“.
The central unit is switched off and the display panel goes off. The ADN-W AM
antenna module connected to the central unit is switched off. All switched-
on and connected wireless conference units are automatically switched off
after 5 minutes.
If you are using the “Conference Manager” software, you can also
switch off all wireless conference units with a mouse click (detailed
information can be found in the ADN system manual).
To switch individual wireless conference units off:
Press the microphone key 7 for 5 seconds
or:
Remove the ADN-W BA battery pack from the conference unit (see „Insert-
ing/removing the battery pack“).
The conference unit switches off. All LEDs go off.
If the conference mode is set to “Push to talk”, you can only switch off
the wireless conference unit by removing the battery pack.
The manual switch-off function via the microphone key can be deacti-
vated (detailed information can be found in the ADN system manual).