User Manual
14 AVX
Putting the products into operation
Putting the receiver into operation
The receiver can be rotated by a maximum angle of 320° around its XLR-3
connector.
Mounting the receiver to a video camera
To mount the receiver to a video camera, proceed as follows:
왘 Plug the receiver‘s rotatable XLR connector into the camera‘s XLR-3 audio
input.
If the video camera has an XLR-3 audio input with P48 phantom power, the
receiver is automatically switched on and off together with the video cam-
era – provided that the phantom power is automatically switched on and
off together with the camera.
왘 Rotate the receiver into position, making sure that it does not disturb dur-
ing filming and that there is – preferably – a direct line of sight to the trans-
mitter.
Mounting the receiver to a digital single-lens reflex camera
To mount the receiver to a DSLR camera, use the supplied EKP AVX adapter.
The adapter consists of a hot shoe adapter and a belt clip.
왘 Loosen the locking screw.
왘 Remove the hot shoe adapter from the belt clip.
왘 Slide the hot shoe adapter onto the hot shoe of the DSLR camera as shown
on the left.
왘 Fasten the hot shoe adapter using the locking screw .
max. 320°