User Manual

AVX 27
Using the products
Displaying or adjusting the receiver‘s audio output
level
To display and correctly adjust the receiver‘s output level:
왘 Make sure that the radio link is established.
왘 If your video or DSLR camera has an automatic level control, the automatic
level control must be deactivated.
The receiver also has an automatic level control which cannot be deacti-
vated. If both the automatic level control of the video camera and the auto-
matic level control of the receiver are active, they will interfere with one
another.
왘 Short-press the AF Out button on the receiver.
The 4-step LED display indicates the current output level. This display auto-
matically goes off after a while.
왘 Check the output level display on the video or DSLR camera while using the
microphone as usual.
The output level is adjusted correctly when the output level display shows
full deflection only during the loudest passages. If your video or DSLR cam-
era has a clipping display, this must never light up.
If the output level is adjusted to low or too high:
왘 Short-press the AF Out button on the receiver while the 4-step LED display
is active.
The audio output level is reduced by one step each time the AF Out button
is pressed. When the lowest output level has been reached, you can press
the AF Out button again to reset the receiver to the highest output level.
왘 Alternatively, you can also adjust the input sensitivity of the video camera.
Auto
Manual
INPUT LEVEL
AF Out
–30 dBu
–20 dBu
–10 dBu
0 dBu
AUDIO
LEVEL