Product specification Dante™ Kit MEB 114-S

PRODUCT SPECIFICATION 2/6
Dante™ Kit MEB 114-S
SPECIFICATIONS
SL DI 4 XLR
Audio Inputs
Input type Balanced and RF filtered
Gain 0 dB, +15 dB, + 30 dB, +45 dB,
software selectable
10 dB pad, software selectable
Input impedance > 1.8 KΩ @ any gain
Maximum input
levels
+18 dBu @ 0 dB gain, with pad
+8 dBu @ 0 dB gain, no pad
-7 dBu @ +15 dB gain, no pad
-22 dBu @ +30 dB gain, no pad
-36 dBu @ +45 dB gain, no pad
Phantom power +48 V, 10 mA per input, software
selectable
Audio performance
EIN -113 dBu
System THD+N < 0.02 % @ any gain
input signal 3 dB below maximum
Frequency response 20 Hz - 20 kHz
Dante™ network
Physical level Standard Ethernet
Connector Single RJ-45
Cable quality CAT-5
Transmission speed 100 Mbps
Daisy chain 2 units when powered by 802.3af
PoE
3 units when powered by ex-
ternal +12 V DC power supply
(Sennheiser NT 12-50CS)
Product properties
Power requirements Class 0 802.3af PoE PD compliant
+12 V DC
Power consumption 2.7 W (225 mA) @ +12 V DC, no
phantom power
5.5 W (460 mA) @ +12 V DC,
10 mA phantom power load per
input
Dimensions (W x H
x D)
219 x 38 x 120 mm
(8.63" x 1.50" x 4.74")
Weight 0.77 kg (1.7 lbs)
Operating tempera-
ture
0 °C - 40 °C
(32 °F - 104 °F)
Transducer principle pre-polarized condenser
microphone
Acoustic principle boundary layer microphone
Pick-up pattern cardioid
Frequency response 40 Hz - 20 kHz
Nominal impedance at
1 kHz
200 Ω
Sensitivity 10 mV/PA
Max. sound pressure level 140 dB
Equivalent noise level 29 dB (A)
Equivalent noise level rated
as per CCIR 468-3
39 dB (CCIR)
Dynamic range 111 dB (A)
Phantom power P24-P48
Current consumption 5.3 mA
Connectors Mic Out - tiny XLR-3M
Logic out high level output voltage >
2.4 V
low level output voltage >
0.4 V
Logic in high level input voltage >
2.0 V
low level input voltage >
0.8 V
LED light ring color red/green
Microphone modes Toggle on / off
Push to mute
Push to talk
permanent on
Connection clip contact for logic
Pin assignment logic
connector
trigger signal at the logic
connector:
Logic in
(LED control)
GND
Logic out
(switch signal)
Weight 291 g
Dimensions (W x D x H) 85 x 100 x 25 mm
(3.35" x 3.94" x 0.98")
Operating temperature -10 °C to +50 °C
(+14 °F to +122 °F)
MEB 114-S