e 901 Instruction manual
Delivery includes Delivery includes • e 901 • pouch • quick guide • safety guide Product overview 1 2 3 2 4 1. Sound inlet basket 2. XLR-3 connector 3. Rubber damping plate 4. Mounting slots Installation Connecting the microphone Connect the XLR-3 socket of the microphone cable (optional accessories) to the XLR-3 socket of the microphone.
Operation Operation Positioning the microphone in a drum Place the e 901 in the drum. Position the microphone so that its sound inlet basket is directed upwards. It is vital to observe the following notes: Position Resulting sound Commentary A Much resonance Much attack Less attack: Turn the microphone away from where the beater strikes. Position the microphone at the bottom of the kick drum, approx. 10–20 cm from the batter head.
Operation C D E Positioning the monitor loudspeakers To prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the highest cancellation of the microphone (approx. 180°).
Cleaning and maintaining the e 901 Cleaning and maintaining the e 901 CAUTION LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT! Liquids entering the housing of the product can cause a short-circuit and damage the electronics. Keep all liquids away from the product. Do not use any solvents or cleansing agents. Disconnect the products from the power supply system and remove rechargeable batteries and batteries before you begin cleaning. Clean all products only with a soft, dry cloth.
Specifications Specifications Transducer principle pre-polarised condenser microphone Frequency response 20 - 20,000 Hz Pick-up pattern half-cardioid Sensitivity (free field, no load) 0.5 mV/Pa Nominal impedance (at 1 kHz) < 100 Ω Min. terminating impedance 1 kΩ Max. sound pressure level (at 1 kHz) 154 dB Phantom powering 48 V Connector XLR-3 Dimensions 126.5 x 105 x 26.
Overview of applications Connector assignment 1 3 2 + + XLR 1 3 + 2 3 + 1 2 XLR 2 3 1 XLR + + XLR BALANCED 6.