e 602-II Instruction manual
Delivery includes Delivery includes • e 602-II • pouch • quick guide • safety guide Product overview 1 2 3 1. sound inlet basket 2. XLR-3 connector 3.
Installation Installation Attaching the microphone Screw the microphone’s built-in mount onto a sufficiently stable microphone stand. Connecting the microphone Connect the XLR-3 socket of the microphone cable (optional accessories) to the XLR-3 socket of the microphone.
Operation Operation Positioning the microphone on a kick drum It is vital to observe the following notes: Position Resulting sound Commentary A much attack little resonance dry Position the microphone at a distance of a few centimeters from the batter head. B less attack much resonance smooth and voluminous Position the microphone at the level of the resonant head. C less Attack Position the microphone in the middle between the batter head and the resonant head.
Cleaning and maintaining the e 602-II Cleaning and maintaining the e 602-II CAUTION LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT! Liquids entering the housing of the product can cause a short-circuit and damage the electronics. Keep all liquids away from the product. Do not use any solvents or cleansing agents. Disconnect the products from the power supply system and remove rechargeable batteries and batteries before you begin cleaning. Clean all products only with a soft, dry cloth.
Specifications Specifications Transducer principle dynamic Frequency response 20 - 16,000 Hz Pick-up pattern cardioid Sensitivity (free field, no load) 0.9 mV/Pa (at 50 Hz) 0.25 mV/Pa (at 1 kHz) Nominal impedance (at 1 kHz) 350 Ω Min.
Overview of applications Connector assignment 1 3 2 + + XLR 1 3 3 3 + 1 2 XLR 2 3 1 XLR + + UNBALANCED + BALANCED 6.3 mm XLR 1 + 2 2 + XLR 6.
