Instruction manual
10
Putting the diversity receiver into operation
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s
flash mount.
Determine where on the perforated plate 씊 the flash mount
adapter 씋 will need to be fastened so that the receiver can best be
attached to the camera.
At this position, place a square nut 씌 under the perforated plate 씊.
Fasten the flash mount adapter 씋 to the perforated plate 씊 using the
square nut 씌.
Lift one side of the belt clip 씍 as shown.
Press down the belt clip 씍 at one fixing point and pull it out of the
receiver housing.
Repeat for the other side.
씊
씋
씌
씍