Radio Microphone Instruction Manual
12
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on
(
see the instruction manual of the trans-
mitter
).
The transmission link is established and the receiver’s RF level display
“RF” 햲 reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the receiver”
on page 30.
Switching the diversity receiver on/off
왘 Push the two battery compartment catches 쐈 and open the battery
compartment cover 쐅.
To switch the diversity receiver on:
왘 Press the ON/OFF button 씈.
The red ON LED 쐏 lights up and the standard display “Frequency/
Name” appears on the display panel.
To switch the diversity receiver off:
왘 Keep the ON/OFF button 씈 pressed until “OFF” appears on the display
panel.
The red ON LED 쐏 goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 30.
When in the operating menu, pressing the ON/OFF button 씈 will
cancel your entry (ESC function) and return you to the current
standard display.
쐈
쐏
쐅
쐈
씈