Firmware Update - Release Notes

RN 1173 v1.5.1 - EK 6042 Firmware Update | 1/2

EK 6042 Firmware

Release Notes

EK 6042

EK 6042 Firmware version 1.5.1

What‘s new?

• Support for 6000 series transmitters

• Screensaver settings (60 seconds / 5 minutes / off)

• Setting to temporarily disable the LEDs

• Display of the license frequency number in the top views

• Frequency ranges for 9000 and 6000 series updated

Firmware-Installation

1. Connect the EK6042 to a PC/Mac using a USB cable

2. Start the EK6042 webinterface in a browser

3. Choose „Firmware update“ on the maintenance page and select this ﬁle

Previous Releases

EK 6042 Firmware version 1.4.2

What‘s new?

This ﬁrmware update will improve response and display of warning messages, e.g. PEAK.

In the past, the use of some analog transmitters led to a very sensitive response of the PEAK

warning, even though there was no audio distortion.

PAGE 1
EK 6042 Firmware Release Notes EK 6042 EK 6042 Firmware version 1.5.1 What‘s new? • Support for 6000 series transmitters • Screensaver settings (60 seconds / 5 minutes / off) • Setting to temporarily disable the LEDs • Display of the license frequency number in the top views • Frequency ranges for 9000 and 6000 series updated Firmware-Installation 1. Connect the EK6042 to a PC/Mac using a USB cable 2. Start the EK6042 webinterface in a browser 3.
PAGE 2
EK 6042 Firmware Release Notes EK 6042 Firmware version 1.3.1 What‘s new? This firmware update will provide EK users with a „Party Dial“ mode. This mode will allow users to quickly jump between pre-programmed frequencies with just one press of a button. Ideal for use cases where it is necessary to quickly change between frequencies. Preparation: The „Party Dial“ uses frequencies from the „License List“.