Users Manual

16 AVX
Putting the products into operation
To insert the accupack into the bodypack transmitter:
왘 Slide the accupack onto the bodypack transmitter as shown.
The accupack locks into place with an audible click.
Attaching the bodypack transmitter to clothing
왘 Use the belt clip to attach the bodypack transmitter to clothing.
- The antenna of the bodypack transmitter should not be touched or cov-
ered during transmission as this would reduce the transmission range.
- There should be a free line of sight between the antenna of the bodypack
transmitter and the receiving antenna.
Connecting a clip-on microphone to the bodypack transmitter
Only connect one of the clip-on microphones recommended by Sennheiser.
These microphones are optimized for the bodypack transmitter.
왘 Connect the jack plug of the clip-on microphone to the 3.5 mm jack socket
(Mic/Line) of the bodypack transmitter.
왘 Lock the jack plug by screwing down the coupling ring.
Putting the clip-on microphones into operation
Putting the MKE 2 into operation
The MKE 2 clip-on microphone is supplied with the Lavalier Set Pro and meets
the highest demands on sound quality and ruggedness.
Using the frequency response caps You can use the supplied frequency response caps to boost the frequency
response of the MKE 2 (e.g. if the sound is too muffled) and to optimize your
recordings by improving the speech intelligibility.
왘 Slip the frequency response cap of your choice onto the microphone capsule
until it locks into place.
- The (small) MZC 2-1 frequency response cap slightly increases the treble
response of the microphone.
- The (large) MZC 2-2 frequency response cap allows you to increase the
treble frequencies to a greater extent.