Instruction manual

13
Using the bodypack transmitter
왘 Slide the MUTE switch 쐇 to the left, to the position MUTE.
The bodypack transmitter reacts as indicated in the table.
The current state of the muting function or the RF signal is displayed on
the display panel of the bodypack transmitter. An additional display
appears on the receiver’s display panel when the pilot tone function is acti-
vated on both bodypack transmitter and receiver and, in addition, this
display has been activated via the “Warnings” menu item on the receiver
(see the instruction manual of the receiver).
Selecting a standard display
Audio signal is muted
Transmitter’s display panel: “MUTE” 햸 is displayed
Receiver’s display panel: “TX Mute” is displayed*
* only when activated on the receiver (see above)
Audio signal is activated (muting is deactivated)
Transmitter’s display panel: “MUTE” 햸 is not displayed
Receiver’s display panel: “TX Mute” is not displayed
RF signal is deactivated
Transmitter’s display panel: Transmission icon 햵 is not displayed
Receiver’s display panel: “RF Mute” is displayed*
* only when activated on the receiver (see above)
RF signal is activated
Transmitter’s display panel: Transmission icon 햵 is displayed
Receiver’s display panel: “RF Mute” is not displayed
You can also deactivate the RF signal on switch-on. For more
information, refer to the chapter “Switching the bodypack trans-
mitter on/off” on page 11.
Using the ON/OFF button, you can also activate/deactivate the RF
signal during operation. To do so, briefly press the ON/OFF button
and proceed as described on page 11.
왘 Press the rocker button to select a standard display:
Contents of the display Selectable standard display
“Frequency/Name”
“Channel/Frequency”
“Channel/Name”
ew300 G3
MHz
543.200
MUTE
P
AF
MHz
543.200
B.Ch: 20.24
MUTE
P
AF
B.Ch: 20.24
MUTE
P
AF
ew300 G3