Instruction manual

10 | SKP 300 G3

Using the plug-on transmitter

To establish a transmission link, proceed as follows:

1. Switch the receiver on (see the receiver’s instruction

manual).

2. Switch the plug-on transmitter on (see next

section).

The transmission link is established and the

receiver’s RF level display “RF” reacts.

If you cannot establish a transmission link between

plug-on transmitter and receiver, read the chapter

“Synchronizing the plug-on transmitter with a receiver”

on page 23.

Switching the plug-on transmitter on/off

To switch the plug-on transmitter on (online operation):

To switch the plug-on transmitter on and to deactivate

the RF signal on switch-on (offline operation):

It is vital to observe the notes on frequency selec-

tion on page 23.

왘 Press the ON/OFF button 8.

The plug-on transmitter transmits an RF

signal. The red ON LED 7 lights up and the

“Frequency/Name” standard display appears

on the display panel. The transmission

icon 4 is displayed.

왘 Keep the ON/OFF button 8 pressed until “RF

Mute Off?” appears on the display panel.

왘 Press the UP/DOWN button.

“RF Mute On?” appears on the display panel.

왘 Press the SET button.

The transmission frequency is displayed but

the plug-on transmitter does not transmit an

RF signal. The transmission icon 4 is not

displayed.

ON/OFF

SET

MHz

543.850

ew300 G3

MUTE

