Instruction manual

SKP 300 G3 | 21
Adjusting settings via the operating menu
Setting the mode for the MUTE switch – “Mute Mode”
For information on how to use the MUTE switch 9 refer
to page 12.
Adjusting the transmission power – “RF Power”
Via the “RF Power” menu item, you can adjust the trans-
mission power in 2 steps (“Low” and “Standard”).
Activating/deactivating the phantom powering –
“PhantomPower 48V”
Via the “PhantomPower 48V” menu item, you can
activate or deactivate the 48V phantom powering for
condenser microphones.
Activating/deactivating the pilot tone transmission –
“Pilot Tone”
Mode Function
“AF On/Off” When the switch is in the MUTE posi-
tion, no audio signal is transmitted.
“RF On/Off” When the switch is in the MUTE posi-
tion, the RF signal is deactivated.
“Disabled” The muting function is deactivated.
It is vital to observe the notes on the enclosed
frequency information sheet!
Call up
“Mute Mode”
Select the
desired setting
Store the setting
Advanced Menu
Mute Mode
Mute Mode
Mute Mode
RF On/OffAF On/Off
“Stored”
Call up
“RF Power”
Select the
desired setting
Store the setting
Advanced Menu
RF Power
Standard
RF Power
Low
RF Power
“Stored”
Call up “Phantom
Power 48V”
Select the
desired setting
Store the setting
Name
Advanced Menu
PhantomPower 4 8 V
Active
PhantomPower 48V
Inactive
“Stored”
PhantomPower 48V
Call up
“Pilot Tone”
Select the
desired setting
Store the setting
Name
Advanced Menu
Pilot Tone
Active
Pilot
Inactive
Pilot
“Stored”