Media Control Protocol for ew G3 and 2000 series

Media control protocol for ew G3 and 2000 series
01/2012 26/37
Cyclic attributes valid for EM only
RF1 [get only by cyclic attributes]
Valid for device EM only
Description
This attribute is sent to media control together with other cyclic attributes.
The first parameter contains the minimum RF value of antenna 1 since last cycle.
The second parameter contains the maximum RF value of antenna 1since last cycle.
0% is consistent to 0 dBμV.
100% is consistent to 40 dBμV.
Values greater than 100 % are possible.
The third parameter contains information if antenna 1 was active since last cycle.
Whenever antenna 1 was active since last cycle Sennheiser device will set this
parameter to 1 even then if most of the time antenna 2 was active since last cycle.
Parameters
Examples
See chapter “Response of cyclic attributes“, page 9.
Name Value Range Get Request Set Request Relative
change
Rf min 0.. greater 100% possible – – No
Rf max 0.. greater 100% possible – – No
Antenna 1 0: Antenna 1 was not
active since last cycle
1: Antenna 1 was at least
once active since last
cycle
– – No