Instruction Manual
Table Of Contents
- Index
- Important safety instructions
- The EM 500 G3 rack-mount receiver
- Delivery includes
- Product overview
- Putting the receiver into operation
- Using the receiver
- Using the operating menu
- Adjustment tips and functions
- Synchronizing transmitters with receivers
- Cleaning the receiver
- Recommendations and tips
- If a problem occurs ...
- Accessories and spare parts
- Specifications
Using the receiver
20
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.
If you cannot establish a transmission link between transmitter and
receiver:
왘 Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.
왘 Read the chapter “Synchronizing transmitters with receivers” on
page 45 and, if necessary, the chapter “If a problem occurs ...” on
page 51.
Switching the receiver on/off
To switch the receiver on:
왘 To switch the receiver to standby mode:
It is vital to observe the notes on frequency selection on page 45.
왘 Briefly press the STANDBY button .
The receiver switches on and the “Receiver Parameters”
standard display appears.
542.625
SKM500
ew500 G3
B.Ch: 20.30
EQ
+ 12dB
P
MHz
PEAK
-10
040
30
20
10
-20
-40
AF
RF
-30
P