Users Manual

Using the L 6000
172
Charging rechargeable batteries
To charge the BA 60, BA 61 and BA 62 rechargeable batteries with the
L 6000 charger, you need the LM 6060, LM 6061 or LM 6062 charging
modules.
Before charging, you have to install the charging modules in the
L 6000 charger. For installation information, see „Installing the
LM 6060, LM 6061 and LM 6062 charging modules in the L 6000“.
Note on the charger firmware
Always use the latest firmware for the L 6000 charger (version 2.0 or later)
to ensure you have access to the full range of functions. You can download
the latest firmware from the following address:
http://www.sennheiser.com/l-6000
Note on the BA 62 rechargeable battery for the SK 6212 bodypack
transmitter
It is possible that new rechargeable batteries cannot be fully charged to
100 % in the first few charging cycles.
The remaining operating time may still be unclear after the first few
charging cycles. This will improve over time after more charging cycles be-
cause the rechargeable battery calibrates itself.
To charge the rechargeable batteries:
▷ Insert the rechargeable battery into the charging module as shown in
the figure until it audibly clicks into place.
The rechargeable batteries can be inserted into the charging modules
only in one direction. You can see the charge level of the rechargeable
batteries from the LEDs on the charging modules (see „Meaning of the
LEDs on the L 6000 charger and LM 6060, LM 6061 and LM 6062
charging modules“).