Users Manual
Installing the EM 6000
46
Installing the EM 6000 in a rack
You can install the EM 6000 2-channel receiver in any conventional 19"
rack. The rack mounting angles are already attached to the device.
Always observe the following information during rack mounting.
▷ Support the EM 6000 after installation in the rack.
Due to the weight and depth of the device, there is a risk that it may
break off in the rack and become damaged as a result.
►
Version A:
▷ Use special rack mounting rails.
▷ The design of the rack used must be suitable for the installation of
these mounting rails.
Version B:
▷ Use a suitable object to support the device on the rear side.
▷ Ensure that this object cannot become loose.
ATTENTION
Material damages caused by devices overheating
When there is insufficient ventilation, the devices mounted in the rack may
overheat.
▷ Ensure that there is sufficient ventilation in the rack, particularly if sev-
eral devices are installed. If necessary, install a fan in the rack.
►