Users Manual

Installing the L 6000 | LM 6060 | LM 6061 | LM 6062
75
To install a charging module in the L 6000 charger:
▷ Completely disconnect the L 6000 charger from the power supply sys-
tem. See „Connecting/disconnecting the L 6000 to/from the power
supply system“.
▷ Unscrew one of the dummy caps on the L 6000.
To do so, you require a Torx 10 screwdriver.
►
▷ Fully slide the charging module into the open charging slot as shown in
the figure.
The charging module can be inserted into the L 6000 housing only in
one direction. The Sennheiser lettering on the charging module must
face upward.
►
▷ Tightly screw on the charging module.
Always use the latest firmware for the L 6000 charger (version 2.0 or later)
to ensure you have access to the full range of functions. You can download
the latest firmware from the following address:
http://www.sennheiser.com/l-6000
For more detailed information about charging the BA 60, BA 61 and
BA 62 rechargeable batteries, see „Charging rechargeable batter-
ies“.