Users Manual

Using the EM 6000
145
Sync Fail
Timeout
The synchronization of the receiving channel with the transmitter was un-
successful. The infrared interface for the receiver may not have been able
to establish a link to the infrared interface of the transmitter.
▷ Hold the transmitter in front of the infrared interface for the receiver
correctly. See „Synchronizing devices“.
Sync Fail
Unsupported Encryption
AES 256 encryption is activated on the EM 6000 but the transmitter does
not support it (SK(M) 9000).
▷ Use an SK 6000 or SKM 6000 if you want to activate encryption.
Encryption Error
Sync Needed
AES 256 encryption was activated on the EM 6000 but is not synchronized
to the transmitter yet. The encryption cannot be activated on the transmit-
ter. Instead, it must be transferred via the Sync function.
▷ Synchronize the receiving channel and the transmitter. See „Synchro-
nizing devices“.
Clock Error
There is a deviation in the clock rate of the word clock (> 120 ppm for
48 kHz or > 120 ppm for 96 kHz) or there is no external word clock.
▷ Check the word clock settings. See „Word clock scenarios for digital
audio (AES3 and Dante™)“.
RF Peak
The RF signal is too strong (> -12 dBm). There is a risk of overloading the
receiver.
▷ Increase the distance between the antennas and the receiver.
▷ Use passive antennas instead of active antennas if possible.
▷ If using active antennas, reduce the antenna amplification.