Instruction manual - Digital 6000 (v4.0)

Using the EM 6000
104
Scan & Auto-Setup menu item
The EM 6000 lets you scan the frequency spectrum and display all of the
free frequencies in the selected frequency range. The automatic frequency
setup can be used to distribute the free frequencies to all of the EM 6000
devices available in the network automatically.
You can select the frequency range to be scanned from the predefined fre-
quencies B1 to B6 or from the user-defined frequency banks U1 to U6 or set
them manually.
The Auto Setup function also helps you set up an equidistant frequency
grid using the E frequency bank intended for this purpose. For more infor-
mation about the equidistant frequency grid, see „Equidistant frequency
grid“.
Alternatively, you can use the Sennheiser Wireless Systems Manager
(WSM) software:
www.sennheiser.com/wsm
Performing a frequency scan and automatic frequency setup
1. Activate the Auto Setup function in the System menu item for all of the
EM 6000 devices in the network that you want to include in the auto-
matic frequency setup. See „System -> Auto Setup menu item“ under
„System menu item“.
If the function is not activated for an EM 6000, the automatic frequency
setup cannot be performed for this EM 6000.
2. Open the Scan & Auto-Setup menu item and start the automatic fre-
quency setup.
The EM 6000 on which you perform the Auto-Setup function is de-
fined as the master device in the network. The other devices adopt the
follower function.
Switch off all transmitters before you perform the scan. If transmit-
ters are still switched on, they are detected as unavailable frequen-
cies and the frequencies that are actually available cannot then be
used.