Release Notes – Firmware v3.2.1 (incl. SKM 6000 v1.1.51 & SK 6212 v1.3.23)

RN 1110 v3.2.1 - Digital 6000 Firmware Update | 3/3
Digital 6000
Release Notes
EM 6000 - Firmware version 2.0.1
(incl. SK/SKM 6000 Firmware version 1.1.26)
EM 6000 and EM 6000 DANTE:
f Command mode for all audio outputs, supporting analog, AES3 and 2 separate Dante streams
f Audio mute function controllable from newly added home screen
f Auto setup: option to dispatch not only the frequency but also the sync settings from the master
device to all slaves
f Function buttons of EM 6000 (SAVE, ESC, SYNC, HEADPHONES) are always illuminated when the
device is switched on
f New sync option to update frequency only. All other transmitter settings will be preserved.
f Bug fixes
EM 6000 DANTE only:
f Dante 4.0 support
f Support for Through and Redundant modes (for EM 6000 DANTE receivers with two Dante ports)
f Dante status information is displayed in Menu -> Dante Settings -> Dante Info:
• Device Type: Dante 1 for device with one Dante port
• Devicy Type: Dante 2 for device with two Dante ports
• Dante network status: OK/Faulty
NOTE: When changing any Dante settings, edit all settings first and then apply all settings by pres-
sing the SAVE button. To discard the changes by pressing the ESC button.
EM 6000 - Firmware version 1.3.0
(incl. SK/SKM 6000 Firmware version 1.1.26)
f Simplification of LOCK mode of SK/SKM
f Blue power LED can be switched off when transmitter is in LOCK mode
f SK: Input signal can be switched between MIC / LINE and automatic detection
f SK: Better low cut filter performance for connected instruments
f SK: Gain setting issue when changing from LINE to MIC input solved
f Bug fixes
EM 6000 - Firmware version 1.2.0
f Auto Setup enable status is ON by default (was OFF before)
f Fix: Issue that the booster feed setting and the loop throuh attenuator setting get lost when the
device is disconnected from the power supply while in standby mode.
f Fix: Issue that the Dante™ output is disabled unintentionally as a result of changes in the word-
clock settings.
f Fix: Issue concerning the brightness consistency on both displays.
f Fix: Possible device crash in some situations caused by network link status change under heavy
network traffic.
f Change for the purpose of conformity: Change of multicast IP address used for the Auto Setup
feature.
f Fix: Issue that the Dante IP address is not updated after changing.
f Fix: Issue that in some situations the wordclock measurement is not displayed correctly in the
second home screen.