Users Manual
Table Of Contents
- Digital_9000_Manual_06_2017_EN
- Important safety instructions
- Digital 9000 – System overview
- Delivery includes
- EM 9046 receiver
- EM 9046 CAB cable set
- Antennas and antenna boosters
- GZL 9000 antenna cables
- SKM 9000/SKM 9000 COM radio microphone
- Microphone heads for the SKM 9000 radio microphone
- SK 9000 bodypack transmitter
- Microphones for the SK 9000 bodypack transmitter
- KA 9000 COM command adapter for the SK 9000 bodypack transmitter
- CI 1-4 line/instrument cable for the SK 9000 bodypack transmitter
- B 60/B 61 battery packs
- BA 60/BA 61 accupack
- L 60 charger
- Product overview
- EM 9046 receiver
- Antennas and antenna boosters
- GZL 9000 antenna cable
- SKM 9000/SKM 9000 COM radio microphone
- SK 9000 bodypack transmitter
- KA 9000 COM command adapter for the SK 9000 bodypack transmitter
- BA 60 accupack
- BA 61 accupack
- B 60 battery pack
- B 61 battery pack
- L 60 charger
- Preparing the EM 9046 receiver for use
- Preparing the A/AB/AD 9000 antennas and/or antenna boosters for use
- Preparing the SKM 9000 radio microphone for use
- Preparing the SK 9000 bodypack transmitter for use
- Preparing the L 60 charger for use
- Cascading several chargers
- Setting up or mounting the charger
- Preparing the Digital 9000 system for use
- Using the EM 9046
- Using the SKM 9000
- Using the SK 9000
- Using the L 60
- Cleaning and maintaining the Digital 9000 system
- If a problem occurs ...
- Specifications
Using the EM 9046
50 | Digital 9000
Using the EM 9046 receiver
Switching the receiver on/off
To switch the receiver on:
왘 Make sure the ON/OFF switch 1 is set to position “1”.
왘 Press the standby button 3.
The receiver’s operating system is loaded
. Durin
g loading, the LED of the
standby button 3 flashes red and the display panel shows the Senn-
heiser start screen. Then, an automatic calibration of the cable attenu-
ation is performed (see page 64).
Once the operating system is fully loaded, the receiver is in “live” oper-
ating mode.
To switch the receiver to standby mode:
왘 Keep the standby button 3 pressed for approx. 4 seconds until the
disp
lay panel goes completely off.
The receiver is in standby mode. All the interferences levels recorded
during the frequency scans are deleted. The activated booster fre-
quency range and the frequency presets assigned to the channels are
stored.
To completely switch the receiver off and disconnect it from the mains:
왘 Set the ON/OFF switch 1 to position “0”.
All daisy chained signals are interrupted, i.e.:
– the antenna signals at the daisy chain outputs G and H,
– the booster supply voltage,
– the signal of the external word clock generator.
왘 Pull out the mains plug from the wall socket to completely disconnect
the receiver from the mains.
3