Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Product overviews
8
Overview of the displays of the EK 300 IEM G3 diversity receiver
After switch-on, the diversity receiver displays the standard display “Frequency/Name”. For further illustrations and
examples of the different standard displays, refer to page 18. The standard display displays the operating states of the
diversity receiver. The display backlighting is automatically reduced after approx. 20 seconds.
Display Meaning
RF level “RF”
(Radio Frequency)
Diversity display:
Antenna input I is active
Antenna input II is active
RF signal level:
Field strength of the received signal
Squelch threshold level
Audio level “AF”
(Audio Frequency)
Peak hold function
Modulation of the transmitter (channel-separated when the transmitter is set to
stereo mode)
When the display shows full deflection, the audio input level is excessively high.
Frequency Current receiving frequency
Name Freely selectable name of the receiver
Lock mode icon Lock mode is activated (see page 18)
Battery status Charge status:
approx. 100%
approx. 70%
approx. 30%
charge status is critical, the red LOW BATT LED is flashing:
Muting function
“MUTE”
“Mute” is only displayed on the “Frequency/Name” standard display (see page 18)
• when the transmitter’s RF signal is deactivated
• or when the transmitter is set to mono mode and therefore does not transmit a pilot tone
but the receiver’s pilot tone evaluation is activated.
or audio channels The audio channels are only displayed on the “Frequency/Limiter” and “Frequency/High
Boost” standard displays (see page 18)
Stereo
Focus
Pilot tone “P” Activated pilot tone evaluation
MHz
519.150
ew300 IEM
P
AFRF
MUTE
P
RF
AF