Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Putting the devices into operation
11
Rack mounting two
transmitters
To mount two transmitters into a rack using the GA 3 rack adapter:
왘 Place the two transmitters side by side upside-down onto a flat surface:
왘 Secure the jointing plate to the transmitters using six recessed head screws (M 3x6).
왘 Secure the rack mount “ears” to the transmitters as described on page 9.
To mount the antennas:
왘 Use remote antennas, if necessary in conjunction with the AC 3 antenna combiner.
For more information, visit the ew G3 product pages at www.sennheiser.com.
To mount the transmitters into the rack:
왘 Slide the transmitters into the 19” rack.
왘 Secure the rack mount “ears” to the 19” rack.
Connecting the mains unit
Only use the supplied mains unit. It is designed for the transmitter and ensures safe
operation.
왘 Insert the yellow connector of the NT 2-3 mains unit into the yellow socket of the
transmitter.
왘 Pass the cable of the mains unit through the cable grip .
왘 Slide the supplied country adapter onto the mains unit .
왘 Plug the mains unit into a wall socket.
The STANDBY button is backlit in red.
The AC 3 antenna combiner incorporates DC distribution to enable simultaneous
powering of up to four transmitters via its BNC sockets. These transmitters do not
require their individual power supply (see also page 12).