Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Putting the devices into operation
14
Putting the EK 300 IEM G3 diversity receiver into operation
Inserting the batteries/accupack
For powering the diversity receiver, you can either use two 1.5 V AA size batteries or the
rechargeable Sennheiser BA 2015 accupack (accessory, see www.sennheiser.com).
왘 Open the battery compartment by pushing the two catches in the direction of the
arrows and open the cover .
왘 Insert the two batteries or the accupack as shown above. Observe correct polarity when
inserting the batteries/accupack.
왘 Close the battery compartment by pressing on the center of the cover .
The battery compartment cover locks into place with an audible click.
Charging the accupack
To charge the BA 2015 accupack (accessory, see www.sennheiser.com) installed in the
diversity receiver:
왘 Insert the diversity receiver into the L 2015 charger (accessory, see
www.sennheiser.com).
The L 2015 charger can only charge the combination BA 2015 accupack/diversity
receiver. Standard batteries (primary cells) or individual rechargeable battery cells
cannot be charged.