Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using the devices
16
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the transmitter on.
2. Switch the diversity receiver on.
The transmission link is established.
왘 If you cannot establish a transmission link between transmitter and receiver, read the
chapter “Synchronizing the transmitter with the diversity receiver” on page 27.
Switching the devices on/off
Switching the SR 300 IEM G3 transmitter on/off
To switch the transmitter on (online operation):
To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation):
To activate the RF signal:
To switch the transmitter to standby mode:
왘 If necessary, deactivate the lock mode (see page 18).
It is vital to observe the notes on frequency selection on page 27.
왘 Press the STANDBY button .
The transmitter switches on and the standard display appears.
The transmission icon
is displayed, the transmitter transmits an RF signal.
왘 Press the STANDBY button until “RF Mute Off?” appears on the display panel.
왘 Turn the jog dial.
“RF Mute On?” appears on the display panel.
왘 Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon
is not displayed. When the display has
been activated via the “Warnings” menu item on the transmitter, “RF Mute”
(backlit in red) appears alternately with the standard display.
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
왘 Briefly press the STANDBY button .
“RF Mute On?” appears on the display panel.
왘 Turn the jog dial.
“RF Mute Off?” appears on the display panel.
왘 Press the jog dial.
The RF signal is activated and the transmission icon
is displayed again.
왘 Keep the STANDBY button pressed until “OFF” appears on the display panel.
The transmitter switches to standby mode.