Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using the operating menus
25
Operating menu of the EK 300 IEM G3 diversity receiver
Reset Resets the settings made in the operating menu
When resetting the settings made in the operating menu, only the selected settings for the pilot
tone and for the frequency banks “U1” to “U6” remain unchanged. For an overview of the
factory-preset default settings, refer to the supplied frequency information sheet.
IP-Address Adjusts the IP address of the transmitter
Software Revision Displays the current software revision
Exit Exits the extended menu “Advanced Menu” and returns to the main menu
“Warnings”
Activates/deactivates the warning messages (color change and warning messages)
AF Peak Audio overmodulation
RF Mute RF signal is deactivated
Exit Exits the submenu “Warnings” and returns to the extended menu “Advanced Menu”
Display Function of the menu item
Main menu “Menu”
Squelch Adjusts the squelch threshold, adjustment range: 5 to 25 dBμV, adjustable in 2-dB steps, can be
switched off
Special function (for servicing purposes only): With the squelch threshold set to “5 dB”, you switch
the squelch off by keeping the DOWN button 왔 pressed for 3 seconds. If you then press the UP
button 왖, you switch the squelch on again.
Easy Setup Scans for unused frequency presets, releases and selects frequency presets
Frequency Preset Sets the frequency bank and the channel
Name Enters a freely selectable name
Balance Adjusts the balance
Mode Selects stereo or Focus mode
High Boost Activates/deactivates the treble boost
Auto Lock Activates/deactivates the automatic lock mode
Advanced Calls up the extended menu “Advanced Menu”
Exit Exits the operating menu and returns to the current standard display
“Easy Setup”
Reset List Releases all locked frequency presets
Current List Selects an unused frequency preset
Display Function of the menu item
CAUTION! Danger of hearing damage and material damage!
If you switch the squelch off or adjust the squelch threshold to a very low value, loud
hissing noise can occur in the receiver. The hissing noise can be loud enough to cause
hearing damage or overload the loudspeakers of your system!
왘 Always make sure that the squelch is switched on (see above).
왘 Before adjusting the squelch threshold, set the volume of the headphone output to
the minimum.
왘 Never change the squelch threshold during a live transmission.