Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using the operating menus
26
Scan New List Scans for unused receiving frequencies (frequency preset scan)
Exit Exits “Easy Setup” and returns to the main menu
Extended menu “Advanced Menu”
Tune Sets the receiving frequencies for the frequency banks “U1” to “U6”
Sets the channel and the receiving frequency for the frequency banks “U1” to “U6”:
왘 Select this menu item and call it up by pressing the SET button until the channel selection
appears.
Pilot Tone Activates/deactivates the pilot tone evaluation
Limiter Adjusts the limiter
Volume Boost Adjusts the volume boost
LCD Contrast Adjusts the contrast of the display panel
Engineer Mode Adjusts the menu item and loading profiles
Reset Resets the settings made in the operating menu
Resets the settings made in the operating menu, only the selected settings for the pilot tone and
for the frequency banks “U1” to “U6” remain unchanged. For an overview of the factory-preset
default settings, refer to the supplied frequency information sheet.
Software Revision Displays the current software revision
Exit Exits the extended menu “Advanced Menu” and returns to the main menu
Display Function of the menu item