Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
If a problem occurs ...
32
Approved by
NT 2-3 mains unit
In compliance with
The mains unit is certified in accordance with the legal safety requirements of Europe, the United States, Canada, Russia
and Japan.
EK 300 IEM G3 diversity receiver
Canada Industry Canada RSS 123
IC: 2099A-G3SREK
limited to 698 MHz
USA FCC-Part 74 FCC-ID: DMOG3SREK
limited to 698 MHz
Input voltage 100 to 240 V~, 50/60 Hz
Current consumption max. 120 mA
Output voltage 12 V
Secondary output current 400 mA
Temperature range –10°C to +40°C
Europe
EMC EN 55022, EN 55024,
EN 55014-1/-2
Safety EN 60065
USA
47 CFR 15 subpart B
Canada ICES 003
Receiver principle adaptive diversity
Sensitivity (with HDX, peak deviation) < 4 μV, typ. 1.6 μV for 52 dBA
rms S/N
Adjacent channel rejection typ. ≥ 65 dB
Intermodulation attenuation typ. ≥ 70 dB
Blocking ≥ 80 dB
Squelch Off, 5 to 25 dBμV, adjustable in steps of 2 dB
Pilot tone squelch evaluation can be switched off
S/N ratio (1 mV, peak deviation) approx. 90 dB
Max. output power 2 x 100 mW at 32 Ω
High Boost +8 dB at 10 kHz
Limiter –18 dB to –6 dB, adjustable in steps of 6 dB, can be switched off
Power supply 2 AA size batteries, 1.5 V or BA 2015 accupack
Nominal voltage 2.4 V