Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Using the devices
17
To completely switch the transmitter off:
왘 Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket. The backlighting of the STANDBY button goes off.
Switching the EK 300 IEM G3 diversity receiver on/off
To switch the diversity receiver on:
왘 Turn the volume control clockwise until it clicks.
The red ON LED lights up. The “Frequency/Name” standard display appears on the
display panel.
To switch the diversity receiver off:
왘 Turn the volume control counterclockwise until it clicks.
The red ON LED goes off and the diversity receiver switches off.
Monitoring the audio signal via headphones
To monitor the audio signal via the headphone output of the diversity receiver:
왘 Connect earphones with a 3.5 mm stereo jack plug to the headphone output .
왘 When switching the receiver on, slowly and carefully turn the volume control clockwise.
왘 Via the receiver’s operating menu (see page 24), adjust:
– stereo or Focus operation (“Mode” menu item)
–the balance (“Balance” menu item)
– the treble boost (“High Boost” menu item)
– the limiter (“Advanced” menu/ “Limiter” menu item)
To monitor the audio signal via the headphone output of the transmitter:
왘 Set the headphone volume control to the minimum position.
왘 Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output .
왘 Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
When in the operating menu, pressing the STANDBY button will cancel your
entry (ESC function) and return you to the standard display.
The STANDBY button
is backlit in red both during operation and in standby
mode.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
왘 Set the volume control to the minimum position before putting the headphones on.
왘 Do not continuously expose yourself to high volumes.
The ground connection of the earphones cable serves as the second antenna for
adaptive diversity operation.
Stereo Transmitter