Instruction manual 300 IEM Series G3 Download300 IEM Series: SR 300 IEM G3 and EK 300 IEM G3
Table Of Contents
- Important safety instructions
- The evolution wireless series ew 300 IEM G3
- The frequency bank system
- Product overviews
- Putting the devices into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Setting up the transmitter on a flat surface
- Mounting the transmitter into a 19” rack
- Connecting the mains unit
- Connecting devices to the input sockets
- Connecting devices to the output sockets
- Connecting a remote antenna to the BNC socket and positioning the antenna
- Connecting the AC 3 antenna combiner to the BNC socket
- Daisy chaining audio signals
- Connecting transmitters in a network
- Putting the EK 300 IEM G3 diversity receiver into operation
- Putting the SR 300 IEM G3 transmitter into operation
- Using the devices
- Switching the devices on/off
- Monitoring the audio signal via headphones
- Deactivating the lock mode temporarily
- Selecting a standard display on the diversity receiver
- Adjusting the audio channels on the transmitter
- Activating/deactivating the RF signal on the transmitter
- Synchronizing transmitters and EK 300 IEM G3 receivers via the infra-red interface
- Using the operating menus
- Synchronizing the transmitter with the diversity receiver
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
Cleaning the devices
28
Using freely selectable frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks
“U1” to “U6”.
If you want to use the frequency banks “U1” to “U6”:
왘 Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
왘 Set each transmitter to the same frequency bank (“U1” to “U6”).
왘 On one of the transmitters, select a channel within this frequency bank (see page 24).
왘 Assign this channel one of the calculated transmission frequencies (see page 24).
Either:
왘 Then carry out the Sync function for each transmitter/receiver pair (see table on page 20,
right-hand column).
This establishes a transmission link between each transmitter/receiver pair.
Or:
왘 Manually set the receiver to the same frequency bank, channel and frequency that you set
on the transmitter (see page 24).
Cleaning the devices
SR 300 IEM G3 transmitter
왘
Before cleaning, disconnect the device from the mains.
왘 Use a cloth to clean the device from time to time. Do not use any solvents or cleansing
agents.
EK 300 IEM G3 diversity receiver
왘
Use a cloth to clean the device from time to time. Do not use any solvents or cleansing
agents.
To ensure that the desired frequencies are intermodulation-free:
왘 Contact your Sennheiser partner (see www.sennheiser.com).
CAUTION! Liquids can damage the electronics of the devices!
Liquids entering the housing of the devices can cause a short-circuit and damage the
electronics.
왘 Keep all liquids away from the devices.
왘 Do not use any solvents or cleansing agents