Instruction manual 300 Series
Table Of Contents
- EW300G3_US.pdf
- LeerSeiteGross.pdf
- EW300G3_529661_0109_US_INT.pdf
- Important safety instructions
- The ew 300 G3 evolution wireless series
- Product overview
- Putting the devices into operation
- Using the devices
- Overview of the operating menus
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
- LeerSeiteGross.pdf
- EW300G3_Rueckseite.pdf
Using the devices
19
To switch the bodypack transmitter off:
If necessary, deactivate the lock mode (see page 21).
To switch the bodypack transmitter on and to deactivate the RF signal on switch-on (offline
operation):
To activate the RF signal:
Briefly press the ON/OFF button .
The bodypack transmitter transmits an RF signal. The transmission icon is
displayed.
The red ON LED lights up and the standard display “Frequency/Name”
appears on the display panel.
You can switch the bodypack transmitter on and deactivate the RF signal on switch-
on. For more information, see below.
Press the ON/OFF button until “OFF” appears on the display panel. The red
ON LED goes off and the display panel turns off.
When in the operating menu, pressing the ON/OFF button will cancel your entry
(ESC function) and return you to the current standard display.
Press the ON/OFF button until “RF Mute On?” appears on the display panel.
Press the SET button .
The transmission frequency is displayed but the bodypack transmitter does not
transmit an RF signal. The transmission icon
is not displayed
. When
the pilot
tone function is activated on both bodypack transmitter and receiver
, “RF Mute”
appears on the receiver’s display panel.
Use this function to save battery power or to prepare a bodypack transmitter for use
during live operation without causing interference to existing transmission links.
Briefly press the ON/OFF button .
“RF Mute Off” appears on the display panel.
Press the SET button .
The transmission icon is displayed again.
ON/OFF
ON/OFF
ON/OFF
SET
MHz
543.200
ew300 G3
MUTE
P
AF
ON/OFF
SET