Instruction manual ew 300-500 G4

Using the EM 300-500 G4

▷ Press the SYNC button to synchronize the selected frequency with the

transmitter immediately.

Current List

▷ Select Current List to show the list of unused frequencies from the last

scan.

Reset

▷ Select Reset List to delete the list of unused frequencies.

Performing multi-channel frequency setup

As an alternative to the following procedure, multi-channel frequency

setup can also be performed using the Sennheiser Wireless Sys-

tems Manager (WSM) software. For more information about con-

trolling devices via the Sennheiser Wireless Systems Manager (WSM)

software, refer to the instruction manual for the software. You can down-

load the software here:

www.sennheiser.com/wsm

To perform the automatic frequency setup for multiple radio links simulta-

neously:

▷ Connect all of the receivers to one network using a network switch. See

“Creating a data network”.

▷ Please note that all receivers must be in the same IP address range.

• The IP addresses can be automatically assigned if there is a DHCP

server in the network.

• If there is no DHCP server in the network, the IP addresses must be

assigned manually. See “Advanced -> IP Address menu item”.

• Assign the IP addresses for all receivers in the 192.168.x.x range (the

link-local range 169.254.x.x is also a possible alternative).

▷ Open the Easy Setup menu item on one of the receivers.

This receiver is the master. You can choose any receiver to be the mas-

ter.

▷ Perform the frequency scan on the master receiver as described above.

▷ From the scan results in the master receiver, select a frequency bank