Instruction manual ew D1
Table Of Contents
- Contents
- Important safety instructions
- Optimum sound the easy way
- Package contents
- Product overviews
- Putting the products into operation
- Avoiding sources of interference
- Direct line of sight recommended
- Putting the receiver into operation
- Fitting the device feet
- Mounting the rack mount “ears”
- Connecting the rod antennas to the receiver
- Mounting the receiver into a 19" rack
- Mounting a single receiver into a rack
- Mounting the rod antennas to the front of the rack
- Mounting two receivers into a rack
- Connecting the receiver to a mixing console
- Connecting receivers in a network
- Connecting the receiver to the power supply system
- Putting the bodypack transmitter into operation
- Preparing the headset microphone for use
- Attaching the clip-on microphone to clothing
- Putting the handheld transmitter into operation
- Recharging the accupack
- Using the products
- Switching the devices on or off
- Checking the charge status of the batteries or accupacks
- Checking the RF signal level
- Muting the bodypack transmitter or the SKM-S D1 handheld transmitter
- Pairing a receiver with a transmitter
- Identifying paired devices
- Using the devices in multi-channel operation
- Switching between the standard display and the extended standard display
- Using the operating menu of the receiver
- Using the buttons for navigation
- Overview of the operating menu of the receiver
- Changing the name of the radio link
- Activating/deactivating the low-cut filter
- Adjusting the equalizer
- Adjusting the de-esser
- Activating/deactivating the dynamic compression
- Resetting the audio settings
- Coarsely adjusting the output level of the receiver (Mic/Line)
- Fine-tuning the output level of the receiver
- Activating/deactivating the lock mode
- Activating/deactivating the MUTE switch of the transmitter
- Adjusting the display brightness
- Calling up help functions
- Retrieving system information
- Resetting the receiver to the factory default settings
- Changing the network configuration
- Displaying the IPv6 address
- Displaying the MAC address
- Performing a walk test (checking the reception quality)
- Controlling, monitoring or updating devices via the network
- Cleaning and maintaining the products
- If a problem occurs ...
- Specifications
- Accessories
- Manufacturer Declarations
18
Putting the products into operation
1 2 rack mount “ears”
2 1 blanking plate
3 1 jointing plate
4 2 R-SMA extension cables
5 Screw-in R-SMA sockets
6 R-SMA connectors with washers and nuts
7 2 blanking plugs for closing off the antenna holes in the blanking plate
8 2 recessed head screws
9 6 recessed head screws
Mounting a single receiver into a rack
왘 Unscrew and remove the four screws located on the sides of the receiver
housing.
왘 Secure the rack mount “ears” 1 to the sides of the receiver using the pre-
viously removed recessed head screws (see right-hand diagram).
Make sure that the angled ends of the rack mount “ears” point forward.
왘 Secure the blanking plate 2 to one of the rack mount “ears” 1 using the
two recessed head screws 8.
Make sure to use the correct side (the one with the round holes) of the
blanking plate 2 to secure it to the rack mount “ear”.
If you want to mount the supplied rod antennas to the front of the rack:
왘 Read the next section.
If you do not want to mount the supplied rod antennas to the front of the rack:
왘 Insert the two blanking plugs 7 into the unused antenna holes.
왘 Slide the receiver into the 19" rack.
왘 Secure the rack mount “ears” 1 and the blanking plate 2 to the rack.
2
1
7