Instruction manual ew D1
Table Of Contents
- Contents
- Important safety instructions
- Optimum sound the easy way
- Package contents
- Product overviews
- Putting the products into operation
- Avoiding sources of interference
- Direct line of sight recommended
- Putting the receiver into operation
- Fitting the device feet
- Mounting the rack mount “ears”
- Connecting the rod antennas to the receiver
- Mounting the receiver into a 19" rack
- Mounting a single receiver into a rack
- Mounting the rod antennas to the front of the rack
- Mounting two receivers into a rack
- Connecting the receiver to a mixing console
- Connecting receivers in a network
- Connecting the receiver to the power supply system
- Putting the bodypack transmitter into operation
- Preparing the headset microphone for use
- Attaching the clip-on microphone to clothing
- Putting the handheld transmitter into operation
- Recharging the accupack
- Using the products
- Switching the devices on or off
- Checking the charge status of the batteries or accupacks
- Checking the RF signal level
- Muting the bodypack transmitter or the SKM-S D1 handheld transmitter
- Pairing a receiver with a transmitter
- Identifying paired devices
- Using the devices in multi-channel operation
- Switching between the standard display and the extended standard display
- Using the operating menu of the receiver
- Using the buttons for navigation
- Overview of the operating menu of the receiver
- Changing the name of the radio link
- Activating/deactivating the low-cut filter
- Adjusting the equalizer
- Adjusting the de-esser
- Activating/deactivating the dynamic compression
- Resetting the audio settings
- Coarsely adjusting the output level of the receiver (Mic/Line)
- Fine-tuning the output level of the receiver
- Activating/deactivating the lock mode
- Activating/deactivating the MUTE switch of the transmitter
- Adjusting the display brightness
- Calling up help functions
- Retrieving system information
- Resetting the receiver to the factory default settings
- Changing the network configuration
- Displaying the IPv6 address
- Displaying the MAC address
- Performing a walk test (checking the reception quality)
- Controlling, monitoring or updating devices via the network
- Cleaning and maintaining the products
- If a problem occurs ...
- Specifications
- Accessories
- Manufacturer Declarations
19
Putting the products into operation
Mounting the rod antennas to the front of the rack
When mounting only one receiver into a rack, you can mount the receiver‘s
antenna connections to the front of the rack. This can improve reception.
왘 Screw the two R-SMA sockets 6 of the R-SMA extension cables to the
blanking plate 2 using the supplied washers and nuts.
왘 Connect the two R-SMA connectors 5 to the R-SMA sockets of the receiver.
왘 Slide the receiver into the 19" rack.
왘 Secure the rack mount “ears” to the rack.
왘 Connect the two 2G4 rod antennas to the R-SMA sockets 6 of the blanking
plate 2.
Mounting two receivers into a rack
You can mount two receivers side by side into a rack.
왘 Place the two receivers side by side upside-down onto a flat surface.
왘 Align the jointing plate 3 over the holes in the bottom sides of the receiv-
ers.
The jointing plate must be placed centrally over the two receivers.
왘 Secure the jointing plate 3 to the receivers using the six recessed head
screws 9.
6
2
1
1
5
3
1
1